Ideally you'd run that flat cable directly to your PC. The flat cables are very thin and are easy to 'hide' if you get the same color as the wall. Get a flat ethernet cable (Cat6 or similar) and run that cable along the walls in the corner. Your device using 5GHz means nothing at this time, as the 2 'mesh' devices are not using 5GHz to talk to each other. This is because 'mesh' devices use 2.4GHz to communicate to each other and microwaves also use 2.4GHz. You could setup a 'mesh' network (if all of your devices support it and are from the same vendor) and those do tend to be semi-reliable, but your bandwidth is limited and any use of a microwave near or in between that wireless signal will cause the wireless to be useless as long as the microwave is in use. Any power surge or dip you get - those devices take the hit and fail. Because of this, you are forced to plug them into the wall. surge) and the surge protector will block/negate those signals. You cannot plug them into a surge protector as the ethernet traffic is seen as power fluctuations (ie. There are devices that plug into the wall sockets (powerline adapters) that will act as a 'wired' solution. Netgear wants you to only buy their stuff, and Linksys only wants you to buy their stuff - so, they design their products to meet the criteria of 'wireless extenders' but not in regards to it working with another vendor.

A Linksys device with a Netgear device will be an endless headache with no resolution. A Netgear device will work reasonably well with another Netgear device. One of the key reasons is that wireless broadcasting devices & extenders/repeaters from different companies do not work well together at all - that is very much by unspoken design. They will be reliable for 1-2 hours, if you are lucky, then they'll become problematic - and it just gets worse from there.

I am also certified with wireless technology.Įxtenders are 100% not worth it.

I have a lot of experience with wireless of all varieties.

Home wifi booster best buy